用戶使用注意事項：

一、防靜電地板適用場所環境要求:

溫度: 10-30°C；相對濕度: RH30-70%；溫度變化率:△T≤15°C/小時,要不凝露； 化學環境:無高腐蝕揮發物質。

二、防靜電地板表面禁止用水沖洗，應用擰干的拖把拖掃，以防地板表面飾層起皮及下部金屬件銹蝕。

三、嚴禁硬物、銳器濟壓、沖擊、劃傷飾面及涂塑層。

四、 地板開啟或安裝，應佩戴防護用具，使用專用吸板器輕拿輕放，不得用吸板器吸著地板行走防止途中脫落傷及入員。

五、禁止直接在板面上推動物體以免造成板面劃傷。

六、對長期重載荷情況，當機器一只腳重量大于地板承載等級的l/3時，應在地板相應部位加輔助1支撐 ,否則易造成地板變形。

七、 不要對地板進行隨意改造；請不要在地板下輻射煤氣管、水管。

八、 避免陽光直接照射，以免防防腐層及飾面層過早變色老化。

Cautions for the operators:

1.Ambient environment requlrements

Temperature 10-30°C, relative humidity RH30-70%, temperature change ratio;ΔT≤15°C/hour, no condensation.

Chemlcal Envlronment: without highly corroslve and evaporative substances.

2.Anti-static raised floor is prohibited to be flushed with water, Instead, it shall be cleaned by dried mop so as to prevent the de-skinning of surfacelayer and rusting of underneath meta1 parts.

3. Do not crush or impact with hard or sharp object, otherwise the facelayer or coating might be scratched.

4.The raised floor shall be installed oropened by the operatorwith mask on, and handled gentlywith the special raised floorlifter Don t movethe raised flooralong with the raised floorlifter, otherwise the raised f1oor might be detached from thelifter, leading to personal lnjury.

5.Do not move any object directly on the raised floor to prevent surface scratch.

6.In case of higher load for long term, when the weight of the machine at one corner foot islarger than 1/3 of the maximum Ioad by the raised floor necessary auxiliary support shall be added to corresponding part to avoid raised floor deformation.

7.The raised f1oor can' t be reformed without permit. Gas pipe and water pipes are not allowed under the raised floor.

8.Don' t expose to direct sunshlne to prevent color aging of ant1-corrosive layer or decorativen layer.